Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
8-50 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.2.13 clear policy disabled-ports
Use this command to clear ports from the disabled state that have been disabled due to the first use
of a policy rule on those ports. This command is only in effect if the port disable function has been
enabled using the set policy rule command as described in Section 8.3.2.4. To become active again,
disabled ports must also be removed from the policy usage list as described in Section 8.3.2.14.
clear policy disabled-ports [all] | port-string
Syntax Description
Command Defaults
If not specified, all disabled ports will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear all disabled ports from the disabled state:
all | port-string Clears all ports or specific port(s) from the disabled state.
Matrix(rw)->clear policy disabled-ports all
To Next Page