Enterasys Matrix 2G4072-52 - Set Spantree Backuproottrapenable

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-82 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.69 set spantree backuproottrapenable
Use this command to enable or disable the Spanning Tree backup root trap function. When SNMP
trap messageing is configured, this sends a trap message when the back up root function makes a
Spanning Tree the new root of the network.
set spantree backuproottrapenable {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the backup root trap function:
enable | disable Enables or disables the backup root trap function.
Matrix(rw)->set spantree backuproottrapenable enable