IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-15
10.4.2.7 set igmp config
Use this command to configure IGMP settings on one or more VLANs.
set igmp config vlan-list {[query-interval query-interval] [igmp-version
igmp-version] [max-resp-time max-resp-time] [robustness robustness]
[last-mem-int last-mem-int]}
Syntax Description
Command Defaults
At least one optional parameter must be specified.
Command Type
Switch command.
Command Mode
Read-Write.
vlan-list Specifies the VLAN(s) on which to configure IGMP.
query-interval
query-interval
(Optional) Specifies the frequency of host-query frame
transmissions. Valid values are from 1 to 65535 seconds.
This value works together with max-resp-time to remove
ports from an IGMP group.
igmp-version
igmp-version
(Optional) Specifies the IGMP version. Valid values are:
• 1 - IGMP V1
• 2 - IGMP V2
max-resp-time
max-resp-time
(Optional) Specifies the maximum query response time.
Valid values are 1 to 25 seconds. This value works together
with query-interval to remove ports from an IGMP group.
robustness
robustness
(Optional) Specifies the robustness value. This can be
increased to tune for expected packet loss on a subnet.
Valid values are 2 to 255.
last-mem-int
last-mem-int
(Optional) Specifies the Last Member Query Interval. This
is the maximum response time inserted into group-specific
queries which are sent in response to Leave Group
messages. It is also the amount of time between
group-specific query messages. Valid values are 1 to 255.
To Next Page
Loading...
