Routing Protocol Configuration Command Set
Configuring IRDP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-89
13.2.5.8 show ip irdp
Use this command to display IRDP information.
show ip irdp [vlan vlan-id]
Syntax Description
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
If vlan vlan-id is not specified, IRDP information for all interfaces will be
displayed.
Example
This example shows how to display IRDP information for VLAN 1:
vlan vlan-id (Optional) Displays IRDP information for a specific
VLAN. This VLAN must be configured for IP routing as
described in Section 2.3.1.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(vlan 1))#show ip irdp vlan 1
Interface 1 is not enabled
To Next Page
Loading...
