Logging And Network Management Command Set
Configuring Node Aliases
11-144 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.7.3 show nodealias protocol
Use this command to display node alias entries based on protocol and protocol address.
show nodealias protocol {ip | apl | mac | hsrp | dhcps | dhcpc | bootps | bootpc |
ospf | vrrp | ipx | xrip | xsap | ipx20 | rtmp | netBios | nbt | bgp | rip | igrp | dec |
bpdu | udp} [ip-address ip-address] [port-string]
Syntax Description
Command Defaults
• If ip-address is not specified for the IP protocol, IP-related entries will be
displayed from all source addresses.
• If port-string is not specified, node alias entries will be displayed for all ports.
Command Mode
Read-Only.
ip | apl | mac |
hsrp | dhcps |
dhcpc | bootps |
bootpc | ospf |
vrrp | ipx | xrip |
xsap | ipx20 |
rtmp
| netBios |
nbt | bgp | rip |
igrp | dec | bpdu |
udp
Specifies the protocol for which to display node alias
entries. Refer back show nodealias mac (Section 11.2.7.2)
for a detailed description of these parameters.
ip-address
ip-address
(Optional) Used for IP protocol only, displays node alias
entries for a specific source address.
port-string (Optional) Displays node alias entries for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.1.
To Next Page
Loading...
