Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-34 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.22 set spantree bridgeprioritymode
Use this command to set the Spanning Tree bridge priority mode to 802.1D (legacy) or 802.1t. This
will affect the range of priority values used to determine which device is selected as the Spanning
Tree root as described in set spantree priority (Section 6.2.1.25).
set spantree bridgeprioritymode {8021d | 8021t}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the bridge priority mode to 802.1D:
8021d Sets the bridge priority mode to use 802.1D (legacy) values
of values, which are 0 - 65535.
8021t Sets the bridge priority mode to use 802.1t values, which
are 0 - 61440, in increments of 4096. Values will be
rounded up or down, depending on the 802.1t value to
which the entered value is closest.
Matrix(rw)->set spantree bridgeprioritymode 8021d
To Next Page
Loading...
Need help?
General