Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-96 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.4 show spantree portadmin
Use this command to display the status of the Spanning Tree algorithm on one or more ports.
show spantree portadmin [port port-string]
Syntax Description
Command Defaults
If port-string is not specified, status will be displayed for all ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display port admin status for fe.1.7:
port port-string (Optional) Displays status for specific port(s). For a
detailed description of possible port-string values, refer
to Section 4.1.1.
Matrix(rw)->show spantree portadmin port fe.1.7
Port fe.1.7 has portadmin set to enable
To Next Page
Loading...
