Logging And Network Management Command Set
Configuring RMON
11-90 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.4.31 set rmon filter
Use this command to configure an RMON filter entry.
set rmon filter index channel_index [offset offset] [status status] [smask smask]
[snotmask snotmask] [data data] [dmask dmask] [dnotmask dnotmask] [owner
owner]
Syntax Description
Command Defaults
• If owner is not specified, it will be set to monitor.
• If no other options are specified, none (0) will be applied.
Command Type
Switch command.
index Specifies an index number for this entry. An entry will
automatically be created if an unused index number is
chosen. Maximum number of entries is 10. Maximum
value is 65535.
channel_index Specifies the channel to which this filter will be applied.
offset offset (Optional) Specifies an offset from the beginning of the
packet to look for matches.
status status (Optional) Specifies packet status bits that are to be
matched.
smask smask (Optional) Specifies the mask applied to status to indicate
which bits are significant.
snotmask snotmask (Optional) Specifies the inversion mask that indicates
which bits should be set or not set
data data (Optional) Specifies the data to be matched.
dmask dmask (Optional) Specifies the mask applied to data to indicate
which bits are significant.
dnotmask dnotmask (Optional) Specifies the inversion mask that indicates
which bits should be set or not set.
owner (Optional) Specifies the name of the entity that
configured this entry.
To Next Page
Loading...
Need help?
General