IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-11
10.4.2.4 show igmp grp-full-action
Use this command to show what action to take with multicast frames when the multicast
IGMP group table is full
show igmp grp-full-action
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the action taken for multicast frames when the IGMP group
table is full:
Matrix(rw)->show igmp grp-full-action
Group Table Full Action: Flood to Vlan
To Next Page
Loading...
