Routing Protocol Configuration Command Set
Configuring IRDP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-81
13.2.5 Configuring IRDP
Purpose
To enable and configure the ICMP Router Discovery Protocol (IRDP) on an interface. This protocol
enables a host to determine the address of a router it can use as a default gateway.
Commands
The commands used to enable and configure IRDP are listed below and described in the associated
section as shown:
• ip irdp (Section 13.2.5.1)
• ip irdp maxadvertinterval (Section 13.2.5.2)
• ip irdp minadvertinterval (Section 13.2.5.3)
• ip irdp holdtime (Section 13.2.5.4)
• ip irdp preference (Section 13.2.5.5)
• ip irdp address (Section 13.2.5.6)
• no ip irdp multicast (Section 13.2.5.7)
• show ip irdp (Section 13.2.5.8)
To Next Page
Loading...
