Enterasys Matrix 2G4072-52 - Configuring Discovery Protocols; Overview; Discovery Protocols Command Set; Displaying Neighbors

Matrix DFE-Platinum and Diamond Series Configuration Guide 3-1
3
Configuring Discovery Protocols
This chapter describes how to configure the discovery protocols supported by the firmware using
CLI commands.
3.1 OVERVIEW
Currently, three discovery protcols are supported:
• The Enterasys Discovery (CDP), described in Section 3.2.2, “Enterasys Discovery Protocol,” on
page 3-4
• The Cisco Discovery Protocol, described in Section 3.2.3, “Cisco Discovery Protocol,” on page
3-12
• The IEEE 802.1AB Link Layer Discovery Protocol (LLDP) and LLDP Media Endpoint
Discovery Protcol (LLDP-MED), described in Section 3.2.4, “Link Layer Discovery Protocol
and LLDP-MED,” on page 3-25
3.2 DISCOVERY PROTOCOLS COMMAND SET
3.2.1 Displaying Neighbors
Purpose
The show neighbors command displays neighbor discovered by all support discovery protocols.
Command
• show neighbors (Section 3.2.1.1)