Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
11-104 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.5.6 show ip route
Use this command to display the switch’s IP routing table entries.
show ip route
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the IP routing table:
Table 11-12 provides an explanation of the command output.
Matrix(rw)->show ip route
ROUTE TABLE
Destination Gateway Mask TOS Flags Refcnt Use Interface
------------------------------------------------------------------------------
default 12.22.73.13 00000000 0 UC 0 0 host0
10.0.0.0 12.22.73.13 ff000000 0 UC 0 host0
127.0.0.1 127.0.0.1 00000000 0 UH 0 104 lo0
Table 11-12 show ip route Output Details
Output What It Displays...
Destination IP address of the host entry.
Gateway MAC address of the destination.
Mask IP mask of the destination.
TOS Type of Service setting.
To Next Page
Loading...
Need help?
General