Discovery Protocols Command Set
Cisco Discovery Protocol
3-18 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.3.4 set ciscodp timer
Use this command to set the number of seconds between Cisco Discovery Protocol PDU
transmissions.
set ciscodp timer time
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the Cisco Discovery Protocol timer to 120 seconds:
time Specifies the number of seconds between CiscoDP PDU
transmissions. Valid values are 5 - 254.
Matrix>set ciscodp timer 120
To Next Page
Loading...
