Enterasys Matrix 2G4072-52 - Show Igmp Reporters

IGMP Configuration Command Set
Configuring IGMP
10-26 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.2.17 show igmp reporters
Use this command to display IGMP reporter information.
show igmp reporters [portlist portlist] [group group] [vlan-list vlan-list] [sip
sip]
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the all IGMP reporter information :
[portlist portlist] portlist - Port or range of ports.
[group group] group - group IP address (none means show all groups)
[vlan-list vlan-list] vlan-list - VLAN ID or range of IDs (1-4094)
[sip sip] sip - source IP address (none means show all sips)
Matrix(rw)->show igmp reporters
IGMP Reporters
Port Group Address Vlan Source IP ExpireTime(Sec) Flags
---------------------------------------------------------------
lag.0.2 224.0.0.251 1 Any 252 DYNAMIC
lag.0.2 239.255.12.43 1 Any 253 DYNAMIC
lag.0.2 239.255.255.250 1 Any 255 DYNAMIC
lag.0.2 239.255.255.250 20 Any 249 DYNAMIC
lag.0.4 235.80.68.83 20 Any 237 DYNAMIC
lag.0.4 239.255.255.250 20 Any 243 DYNAMIC