Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
8-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.3.13 set cos port-resource txq
Use this command to configure a Class of Service transmit queue port resource entry.
set cos port-resource txq group-type-index transmit-queue {[unit {percentage |
kbps | mbps | gbps}] [rate rate] [algorithm {tail-drop}]}
Syntax Description
Command Defaults
• If a rate is not specified, port defaults will be applied.
• If not specified, no algorithm will be assigned.
Command Type
Switch command.
Command Mode
Read-Write.
group-type-index Specifies a transmit queue port group/type index for this
entry. Valid entries are in the form of group.type. Group
can be 0-7, with 0 designating the default group, and 1-7
reserved for user-defined groups. Default port type values
cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
transmit-queue Specifies a transmit queue to be associated with this
entry. Valid values are 0-7.
unit percentage |
kbps | mbps | gbps
Specifies the unit of measure as percentage of total
bandwidth, or kilobits, megabits, or gigabits per second.
rate rate (Optional) Specifies a data rate in units for this transmit
queue.
algorithm tail-drop (Optional) Sets the algorithm by which transmit frames
are discarded as discarding frames from the tail of the
queue.
To Next Page
Loading...
