Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-108 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.16 show spantree adminpathcost
Use this command to display the admin path cost for a port on one or more Spanning Trees.
show spantree adminpathcost [port port-string] [sid sid]
Syntax Description
Command Defaults
• If port-string is not specified, admin path cost for all Spanning Tree ports will
be displayed.
• If sid is not specified, admin path cost for Spanning Tree 0 will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the admin path cost for fe.3.4 on SID 1:
port port-string (Optional) Displays the admin path cost value for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1
.
sid sid (Optional) Displays the admin path cost for a specific
Spanning Tree identifier. Valid values are 0 - 4094. If not
specified, SID 0 will be assumed.
Matrix(rw)->show spantree adminpathcost port fe.3.4 sid
1
Port fe.3.4 has a Port Admin Path Cost of 0 on SID 1
To Next Page
Loading...
