Enterasys Matrix 2G4072-52 - Set Logging here

Logging And Network Management Command Set
Configuring System Logging
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-23
11.2.1.14 set logging here
Use this command to enable or disable the current CLI session as a Syslog destination. The effect
of this command will be temporary if the current CLI session is using Telnet or SSH, but persistent
on the console.
set logging here {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This command shows how to enable the display of logging messages to the current CLI session:
enable | disable Enables or disables display of logging messages for the
current CLI session.
Matrix(rw)->set logging here enable