Enterasys Matrix 2G4072-52 - Starting and Configuring Telnet

General Configuration Command Set
Starting and Configuring Telnet
2-122 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.8 Starting and Configuring Telnet
Purpose
To enable or disable Telnet, and to start a Telnet session to a remote host. The Matrix Series device
allows a total of four inbound and / or outbound Telnet session to run simultaneously.
Commands
The commands used to enable, start and configure Telnet are listed below and described in the
associated section as shown.
• show telnet (Section 2.2.8.1)
• set telnet (Section 2.2.8.2)
• telnet (Section 2.2.8.3)
• show router telnet (Section 2.2.8.4)
• set router telnet (Section 2.2.8.5)
• clear router telnet (Section 2.2.8.6)