Enterasys Matrix 2G4072-52 - Show Port Txq

Port Priority and Rate Limiting Configuration Command Set
Configuring Quality of Service (QoS)
9-12 Matrix DFE-Platinum and Diamond Series Configuration Guide
9.3.3.1 show port txq
Use this command to display QoS transmit queue information for one or more ports.
show port txq [port-string]
Syntax Description
Command Defaults
If the port-string is not specified, the QoS setting of all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the current algorithm and transmit queue weights configured
on fe.2.1 through 5:
port-string (Optional) Specifies port(s) for which to display QoS
settings. For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show port txq fe.2.1-5
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7 Q8 Q9 Q10 Q11 Q12 Q13 Q14 Q15
----- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- ---
fe.2.1 STR 25% 25% 25% 25% N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A
fe.2.2 STR 25% 25% 25% 25% N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A
fe.2.3 STR 25% 25% 25% 25% N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A
fe.2.4 STR 25% 25% 25% 25% N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A
fe.2.5 STR 25% 25% 25% 25% N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A