Matrix DFE-Platinum and Diamond Series Configuration Guide 12-1
12
IP Configuration
This chapter describes the Internet Protocol (IP) configuration set of commands and how to use
them.
12.1 PROCESS OVERVIEW: INTERNET PROTOCOL (IP)
CONFIGURATION
Use the following steps as a guide to configuring IP on the device:
1. Configuring routing interface settings (Section 12.2.1)
2. Managing router configuration files (Section 12.2.2)
3. Performing a basic router configuration (Section 12.2.3)
4. Reviewing and configuring the ARP table (Section 12.2.4)
5. Reviewing and configuring broadcast settings (Section 12.2.5)
6. Reviewing IP traffic and configuring routes (Section 12.2.6)
7. Configuring PIM (Section 12.2.7)
8. Configuring Load Sharing Network Address Translation (LSNAT) (Section 12.2.8)
9. Configuring Dynamic Host Configuration Protocol (DHCP) (Section 12.2.9)
ROUTER: Unless otherwise noted, the commands covered in this chapter can be
executed only when the device is in router mode. For details on how to enable router
configuration modes, refer to Section 2.3.3.
To Next Page
Loading...
Need help?
General