Spanning Tree Configuration Command Set
Configuring Spanning Tree Loop Protect Features
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-119
6.2.3 Configuring Spanning Tree Loop Protect Features
Purpose
To display and set Spanning Tree Loop Protect parameters, including the global parameters of Loop
Protect threshold, window, enabling traps, and disputed BPDU threshold, as well as per port and
port/SID parameters. See “Loop Protect” on page 6-2 for more information about the Loop Protect
feature.
Commands
The commands used to review and set Spanning Tree Loop Protect parameters are listed below and
described in the associated section as shown.
• set spantree lp (Section 6.2.3.1)
• show spantree lp (Section 6.2.3.2)
• clear spantree lp (Section 6.2.3.3)
• show spantree lplock (Section 6.2.3.4)
• clear spantree lplock (Section 6.2.3.5)
• set spantree lpcapablepartner (Section 6.2.3.6)
• show spantree lpcapablepartner (Section 6.2.3.7)
• clear spantree lpcapablepartner (Section 6.2.3.8)
• set spantree lpthreshold (Section 6.2.3.9)
• show spantree lpthreshold (Section 6.2.3.10)
• clear spantree lpthreshold (Section 6.2.3.11)
• set spantree lpwindow (Section 6.2.3.12)
• show spantree lpwindow (Section 6.2.3.13)
• clear spantree lpwindow (Section 6.2.3.14)
• set spantree lptrapenable (Section 6.2.3.15)
• show spantree lptrapenable (Section 6.2.3.16)
• clear spantree lptrapenable (Section 6.2.3.17)
To Next Page
Loading...
Need help?
General