Enterasys Matrix 2G4072-52 - Clear Sntp Server

Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-127
11.2.6.5 clear sntp server
Use this command to remove one or all servers from the SNTP server list.
clear sntp server {ip-address | all}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to remove the server at IP address 10.21.1.100
from the SNTP server list:
ip-address Specifies the IP address of a server to remove from the
SNTP server list.
all Removes all servers from the SNTP server list.
Matrix(rw)->clear sntp server 10.21.1.100