Enterasys Matrix 2G4072-52 - Set Sntp Client

Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-124 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.6.2 set sntp client
Use this command to set the SNTP operation mode.
set sntp client {broadcast | unicast | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable SNTP in broadcast mode:
broadcast Enables SNTP in broadcast client mode.
unicast Enables SNTP in unicast (point-to-point) client mode. In
this mode, the client must supply the IP address from which
to retrieve the current time.
disable Disables SNTP.
Matrix(rw)->set sntp client broadcast