IP Configuration Command Set
Configuring PIM
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-53
12.2.7.3 ip pim dr-priority
Use this command to set the priority for which a router will be elected as the designated router (DR).
ip pim dr-priority priority
Syntax Description
Command Syntax of the “no” Form
The no form of this command disables the DR functionality:
no ip dr-priority
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example sets the DR priority to 20 on VLAN 1:
priority Specifies a priority value for designated router selection.
Valid values are 0 - 4294967294. Default is 1.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip pim dr-priority 20
To Next Page
Loading...
