General Configuration Command Set
Setting Basic Device Properties
2-42 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3 Setting Basic Device Properties
Purpose
To display and set the system IP address and other basic system (device) properties, including time,
contact name and alias, physical asset IDs for modules, terminal output, timeout, and version
information.
Commands
The commands used to set basic system information are listed below and described in the associated
section as shown.
• show ip address (Section 2.2.3.1)
• set ip address (Section 2.2.3.2)
• clear ip address (Section 2.2.3.3)
• show ip gratuitous-arp (Section 2.2.3.4)
• set ip gratuitous-arp (Section 2.2.3.5)
• clear ip gratuitous-arp (Section 2.2.3.6)
• show system (Section 2.2.3.7)
• show system hardware (Section 2.2.3.8)
• show system utilization (Section 2.2.3.9)
• set system utilization threshold (Section 2.2.3.10)
• clear system utilization (Section 2.2.3.11)
• show time (Section 2.2.3.12)
• set time (Section 2.2.3.13)
• show summertime (Section 2.2.3.14)
• set summertime (Section 2.2.3.15)
• set summertime date (Section 2.2.3.16)
• set summertime recurring (Section 2.2.3.17)
• clear summertime (Section 2.2.3.18)
• set prompt (Section 2.2.3.19)
To Next Page
Loading...
Need help?
General