Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-105
6.2.2.13 set spantree porthello
Use this command to set the hello time for one or more Spanning Tree ports. This is the time interval
(in seconds) the port(s) will transmit BPDUs.
set spantree porthello port-string interval
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the hello time to 3 seconds for port fe.1.4:
NOTE: This command can be executed only if bridge hello mode is disabled. For
information on using the
set spantree bridgehellomode command, refer to
Section 6.2.1.28.
port-string Specifies the port(s) for which to set hello time.
interval Specifies the number of seconds the system waits before
broadcasting a bridge hello message. Valid values are 1 -
10.
Matrix(rw)->set spantree porthello fe.1.4 3
To Next Page
Loading...
