Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-27
6.2.1.15 set spantree mstmap
Use this command to map one or more filtering database IDs (FIDs) to a SID. Since VLANs are
mapped to FIDs, this essentially maps one or more VLAN IDs to a Spanning Tree (SID).
set spantree mstmap fid [sid sid]
Syntax Description
Command Defaults
If sid is not specified, FID(s) will be mapped to Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to map FID 3 to SID 2:
fid Specifies one or more FIDs to assign to the MST. Valid
values are 1 - 4093, and must correspond to a VLAN ID
created using the set vlan command as described in
Section 7.3.2.1.
sid sid (Optional) Specifies a Multiple Spanning Tree ID. Valid
values are 1 - 4094, and must correspond to a SID created
using the set msti command as described in
Section 6.2.1.12.
Matrix(rw)->set spantree mstmap 3 sid 2
To Next Page
Loading...
