General Configuration Command Set
Setting User Accounts and Passwords
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-35
2.2.1.9 set system lockout
Use this command to set the number of failed login attempts before locking out (disabling) a
read-write or read-only user account, and the number of minutes to lockout the default admin super
user account after maximum login attempts. Once a user account is locked out, it can only be
re-enabled by a super user with the set system login command (Section 2.2.1.2).
set system lockout {[attempts attempts] [time time]}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Super User.
Examples
This example shows how to set login attempts to 5 and lockout time to 30 minutes:
attempts attempts Specifies the number of failed login attempts allowed
before a read-write or read-only user’s account will be
disabled. Valid values are 1 to 10.
time time Specifies the number of minutes the default admin user
account will be locked out after the maximum login
attempts. Valid values are 0 to 60.
Matrix(su)->set system lockout attempts 5 time 30
To Next Page
Loading...
