Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-58 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.45 show spantree tctrapsuppress
Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
show spantree tctrapsuppress
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of topology change trap suppression:
Matrix(rw)->show spantree tctrapsuppress
Topology change trap suppression is currently enabled.
To Next Page
Loading...
Need help?
General