Port Configuration Command Set
Setting Flow Control
4-64 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.7.1 show port flowcontrol
Use this command to display the flow control state for one or more ports.
show port flowcontrol [port-string]
Syntax Description
Command Defaults
If port-string is not specified, flow control information for all ports will be
displayed.
Command Mode
Read-Only.
Example
This example shows how to display the port flow control state for fe.1.1-5:
Table 4-4 provides an explanation of the command output.
port-string (Optional) Displays flow control state for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.1.
Matrix(rw)->show port flowcontrol fe.1.1-5
Port TX Admin TX Oper RX Admin RX Oper TX Pause Count RX Pause Count
------------ -------- -------- -------- -------- -------------- --------------
fe.1.1 enabled disabled enabled disabled 0 0
fe.1.2 enabled disabled enabled disabled 0 0
fe.1.3 enabled enabled enabled enabled 0 0
fe.1.4 enabled disabled enabled disabled 0 0
fe.1.5 enabled disabled enabled disabled 0 0
Table 4-4 show port flow control Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible
port-string values, refer to Section 4.1.1.
TX Admin Whether or not the port is administratively enabled or
disabled for sending flow control frames.
To Next Page
Loading...
