Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14-106 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.8.4 show cep port
Use this command to display enable status of all supported CEP types.
show cep port port-string
Syntax Description
Command Defaults
None
Command Mode
Read-Only.
Examples
This example shows how to display CEP status information for port fe.1.21:
port-string Displays CEP status for one or more ports. For a detailed
description of possible port-string values, refer to
Section 4.1.1.
Matrix>show cep port fe.1.21
Port H323 Siemens Cisco SIP
---------- -------- -------- -------- --------
fe.1.21 enabled enabled enabled disabled
To Next Page
Loading...
