IGMP Configuration Command Set
Enabling / Disabling IGMP
10-4 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.1.1 show igmp enable
Use this command to display the status of IGMP on one or more VLAN(s).
show igmp enable vlan-list
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the IGMP status for VLAN 104:
vlan-list Specifies the VLAN(s) for which to display IGMP status.
Matrix(rw)->show igmp enable 104
IGMP Default State for vlan 104 is Disabled
To Next Page
Loading...
