Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-29
3.2.4.2 show lldp port status
Use this command to display the LLDP status of one or more ports. The command lists the ports
that are enabled to send and receive LLDPPDUs. Ports are enabled or disabled with the set lldp port
status command.
show lldp port status [port-string]
Syntax Description
Command Defaults
If port-string is not specified, LLDP status information will be displayed for all
ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display LLDP port status information for all ports.
port-string (Optional) Displays LLDP status for one or a range of
ports.
Matrix(ro)->show lldp port status
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12; ge.5.1-12;
tg.6.1-2; fe.7.1-48
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12; ge.5.1-12;
tg.6.1-2; fe.7.1-48
To Next Page
Loading...
Need help?
General