Enterasys Matrix 2G4072-52 - Set Spantree Mstcfgid

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-31
6.2.1.19 set spantree mstcfgid
Use this command to set the MST configuration name and/or revision level.
set spantree mstcfgid {cfgname name | rev level}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the MST configuration name to “mstconfig”:
cfgname name Specifies an MST configuration name.
rev level Specifies an MST revision level. Valid values are 0 -
65535.
Matrix(rw)->set spantree mstconfigid cfgname mstconfig