Enterasys Matrix 2G4072-52 - Configuring TACACS

Security Configuration Command Set
Configuring TACACS+
14-24 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.4 Configuring TACACS+
Purpose
To perform the following:
• Review the TACACS+ client and server configurations on the device.
• Enable or disable the TACACS+ client.
• Set local and remote login options.
• Set server parameters, including IP address, timeout period, server port, and secret.
• Reset TACACS+ client and server settings to default values.
Commands
The commands used to review and configure TACACS+ are listed below and described in the
associated section as shown:
• show tacacs (Section 14.3.4.1)
• set tacacs (Section 14.3.4.2)
• show tacacs server (Section 14.3.4.3)
• set tacacs server (Section 14.3.4.4)
• clear tacacs server (Section 14.3.4.5)
• show tacacs session (Section 14.3.4.6)
• set tacacs session (Section 14.3.4.7)
• clear tacacs session (Section 14.3.4.8)
• show tacacs command (Section 14.3.4.9)
• set tacacs command (Section 14.3.4.10)
• show tacacs singleconnect (Section 14.3.4.11)
• set tacacs singleconnect (Section 14.3.4.12)