Enterasys Matrix 2G4072-52 - Set Cos Port-Config Irl

Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
8-68 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.3.6 set cos port-config irl
Use this command to set the Class of Service inbound rate limiting port group configuration:
set cos port-config irl group-type-index [name name] [ports port-list] [append] |
[clear]
Syntax Description
Command Defaults
• If a name is not specified, default names described in Table 8-5 will be applied.
• If not specified, this configuration will be applied to all ports in the port group.
• If append or clear are not specified, port(s) will be appended to the specified
port grouping.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create a CoS inbound rate limiting port group entry named “test irl”
with a port group ID of 1 and a port type ID of 1:
group-type-index Specifies an inbound rate limiting port group/type index
for this entry. Valid entries are in the form of group.type.
Group can be 0-7, with 0 designating the default group,
and 1-7 reserved for user-defined groups. Default port
type values cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
name name (Optional) Specifies a name for this configuration.
ports port-list (Optional) Applies this configuration to one or more ports
in the port group.
append | clear (Optional) Appends or clears port designations from a
previously configured port group.
Matrix(rw)->set cos port-config irl 1.1 name test irl