Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-110 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.18 clear spantree adminpathcost
Use this command to reset the Spanning Tree default value for port admin path cost to 0.
clear spantree adminpathcost port-string [sid sid]
Syntax Description
Command Defaults
If sid is not specified, admin path cost will be reset for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the admin path cost to 0 for fe.3.2 on SID 1:
port-string Specifies the port(s) for which to reset admin path
cost. For a detailed description of possible port-string
values, refer to Section 4.1.1
.
sid sid (Optional) Resets the admin path cost for specific
Spanning Tree(s). Valid values are 0 - 4094. If not
specified, SID 0 is assumed.
Matrix(rw)->clear spantree adminpathcost fe.3.2 sid 1
To Next Page
Loading...
