Logging And Network Management Command Set
Configuring SMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-41
11.2.3.4 show smon vlan
Use this command to display SMON (Switched Network Monitoring) VLAN statistics.
show smon vlan [port-string] [vlan vlan-id]
Syntax Description
Command Defaults
• If port-string is not specified, SMON statistics for all ports will be displayed.
• If vlan-id is not specified, statistics for all VLANs will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SMON VLAN 1 statistics for 1-Gigabit Ethernet port 14 in
module 3:
port-string (Optional) Displays SMON VLAN statistics being
collected by specific port(s). For a detailed description of
possible port-string values, refer to Section 4.1.1.
vlan vlan-id (Optional) Displays SMON statistics associated with a
specific VLAN.
Matrix(rw)->show smon vlan ge.3.14 vlan 1
Show VLAN Statistics
--------------------
Interface = ge.3.14
Owner = none
Creation = 0 days 16 hours 4 minutes 34 seconds
Status = enabled
--------------------
VLAN 1 Packets Octets
Total 8011072 2070785503
Overflow 0 0
NonUnicast 0 0
NonUnicast Overflow 0 0
To Next Page
Loading...
