Routing Protocol Configuration Command Set
Configuring IRDP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-83
13.2.5.2 ip irdp maxadvertinterval
Use this command to set the maximum interval in seconds between IRDP advertisements.
ip irdp maxadvertinterval interval
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the maximum advertisement interval to the
default value of 600 seconds:
no irdp maxadvertinterval
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the maximum IRDP advertisement interval to 1000 seconds on
VLAN 1:
interval Specifies a maximum advertisement interval in seconds.
Valid values are 4 to 1800.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip irdp maxadvertinterval 1000
To Next Page
Loading...
Need help?
General