General Configuration Command Set
Configuring Power over Ethernet (PoE)
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-107
2.2.5.10 set inlinepower threshold
Use this command to set the PoE usage threshold on a specified module.
set inlinepower threshold usage-threshold module-number
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the PoE threshold to 50 on module 1:
usage-threshold Specifies a PoE threshold as a percentage of total system
power usage. Valid values are 1 - 99.
module-number Specifies the module on which to set the PoE threshold.
Matrix(rw)->set inlinepower threshold 50 1
To Next Page
Loading...
