Port Configuration Command Set
Reviewing Port Status
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-25
4.3.2.1 show port
Use this command to display whether or not one or more ports are enabled for switching.
show port [port-string]
Syntax Description
Command Defaults
If port-string is not specified, operational status information for all ports will be
displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display operational status information for 1-Gigabit Ethernet port 14 in
module 3:
port-string (Optional) Displays operational status for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.1.
Matrix(rw)->show port ge.3.14
Port ge.3.14 enabled
To Next Page
Loading...
