Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-75
4.3.8.5 set linkflap
Use this command to enable or disable link flap monitoring on one or more ports.
set linkflap portstate {disable | enable} [port-string]
Syntax Description
Command Defaults
If port-string is not specified, all ports will be disabled or enabled.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the link trap monitoring on all ports:
disable | enable Disables or enables the link flap detection function.
port-string (Optional) Specifies the port(s) on which to disable or
enable monitoring. For a detailed description of possible
port-string values, refer to Section 4.1.1.
Matrix(rw)->set linkflap portstate enable
To Next Page
Loading...
