Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-46 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.4.13 set lldp port status
Use this command to enable or disable transmitting and processing received LLDPDUs on a port
or range of ports.
set lldp port status {tx-enable | rx-enable | both | disable} port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports ge.1.1 through ge.1.6.
tx-enable Enable transmitting LLDPDUs on the specified ports.
rx-enable Enable receiving and processing LLDPDUs from remote
systems on the specified ports.
both Enable both transmitting and processing received
LLDPDUs on the specified ports.
disable Disable both transmitting and processing received
LLDPDUs on the specified ports.
port-string Specifies the port or range of ports to be affected.
Matrix(rw)->set lldp port status both ge.1.1-6
To Next Page
Loading...
Need help?
General