Logging And Network Management Command Set
Configuring RMON
11-76 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.4.20 set rmon topN properties
Use this command to configure an RMON topN entry (report).
set rmon topn properties index [hindex hindex] [rate {inpackets | outpackets |
inoctets | outoctets | errors | bcast | mcast}] [duration duration] [size size]
[owner owner]
Syntax Description
Command Defaults
• If host index is not specified, none will be applied.
• If counter type is not specified, inpackets will be applied.
• If duration is not specified, none will be applied.
• If size is not specified, 10 will be applied.
• If owner is not specified, monitor will be applied.
Command Type
Switch command.
index Specifies an index number for this entry. An entry will
automatically be created if an unused index number is
chosen. Maximum number of entries is 10. Maximum
value is 65535.
hindex hindex (Optional) Specifies an index number of the host table.
rate inpackets |
outpackets |
inoctets | outoctets |
errors | bcast |
mcast
(Optional) Specifies the type of counter to activate with
this entry as InPackets, OutPackets, InOctets, OutOctets,
OutErrors, Broadcast packets, or Multicast packets.
duration duration (Optional) Specifies the sampling interval in seconds.
Value must be a minimum of 60.
size
size (Optional) Specifies the maximum number of entries to
maintain.
owner owner (Optional) Specifies the name of the entity that
configured this entry.
To Next Page
Loading...
Need help?
General