Logging And Network Management Command Set
Configuring RMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-75
Table 11-9 provides an explanation of the command output. Properties are set using
the set rmon topN properties command as described in Section 11.2.4.20.
Table 11-9 show rmon topN Output Details
Output What It Displays...
Index Index number for this event entry. Each entry defines one
top N report prepared for one interface.
Status Whether this event entry is enabled (valid) or disabled.
Owner Text string identifying who configured this entry.
Start Time System up time when this report was last started.
HostIndex Index number of the host table for which this top N report
will be prepared.
Rate Base Type of counter (and corresponding integer value) activated
with this entry: as InPackets (1), OutPackets (2), InOctets (3),
OutOctets (4), OutErrors (5), Broadcast packets (6), or
Multicast packets (7).
Duration Collection time (in seconds) for this report.
Time Remaining Collection time left for this report if still in progress.
Requested Size Maximum number of hosts requested for the top N table.
Granted Size Actual maximum number of hosts in the top N table.
Depending on system resources, this may differ from the
Requested Size value.
Rate Amount of change in the counter type (InPackets,
OutPackets, etc.) during the sampling interval.
Address MAC address of the host.
To Next Page
Loading...
Need help?
General