Logging And Network Management Command Set
Configuring Node Aliases
11-140 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.7.1 show nodealias
Use this command to display node alias properties for one or more ports.
show nodealias [port-string]
Syntax Description
Command Defaults
If port-string is not specified, node alias properties will be displayed for all ports.
Command Mode
Read-Only.
Example
This example (a portion of the command output) shows how to display node alias properties for
ge.3.12:
Table 11-15 provides an explanation of the command output.
port-string (Optional) Displays node alias properties for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show nodealias ge.3.12
Alias ID = 1533917044 Active = true
Vlan ID = 1 MAC Address = 00-e0-63-04-7b-00
Protocol = ip Source IP = 63.214.44.63
Table 11-15 show nodealias Output Details
Output What It Displays...
Alias ID Alias dynamically assigned to this port.
NOTE:
Node aliases are dynamically assigned
upon packet reception to ports enabled with an alias
agent, which is the default setting on Matrix Series
devices. Node aliases cannot be statically created,
but can be deleted using the
clear node alias
command (Section 11.2.7.7).
Active Whether or not this node alias entry is active.
To Next Page
Loading...
Need help?
General