Enterasys Matrix 2G4072-52 - Set Console Stopbits

Port Configuration Command Set
Setting Console Port Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-19
4.3.1.13 set console stopbits
Use this command to set the stop bits per character for one or more console ports.
set console stopbits {one | oneandhalf | two} [port-string]
Syntax Description
Command Defaults
If port-string is not specified, stop bits per character will be set for all console ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set stop bits per character to 2 for console port com.1.1:
one |
oneandhalf |
two
Sets stop bits per character to 1, 1.5 or 2.
port-string (Optional) Sets stop bits for specific console port(s).
Matrix(rw)->set console stopbits 2 com.1.1