Security Configuration Command Set
Configuring TACACS+
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-25
14.3.4.1 show tacacs
Use this command to display the current TACACS+ configuration information and status.
show tacacs [state]
Syntax Description
Command Defaults
If state is not specified, all TACACS+ configuration information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display all TACACS configuration information:
Table 14-2 provides an explanation of the command output.
state (Optional) Displays only the TACACS+ client status.
Matrix(ro)->show tacacs
TACACS+ state: enabled
TACACS+ session accounting state: disabled
TACACS+ command authorization state: disabled
TACACS+ command accounting state: disabled
TACACS+ single-connect state: disabled
TACACS+ service: exec
TACACS+ session authorization A-V pairs:
access level attribute value
read-only 'priv-lvl' '0'
read-write 'priv-lvl' '1'
super-user 'priv-lvl' '15'
TACACS+ Server IP Address Port Timeout Status
-------------- --------------- ----- ------- -------
1 10.1.26.245 49 10 Active
To Next Page
Loading...
