General Configuration Command Set
Configuring Power over Ethernet (PoE)
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-103
2.2.5.6 set inlinepower powertrap
Use this command to disable or enable the sending of an SNMP trap message whenever the status
of the chassis PoE power supplies or the PoE system redundancy changes.
set inlinepower powertrap {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable a chassis power supplies trap:
disable |
enable
Disables or enables a chassis power supplies trap messaging.
Matrix(rw)->set inlinepower powertrap enable
To Next Page
Loading...
