Security Configuration Command Set
Configuring Port Web Authentication (PWA)
14-54 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.6.1 show pwa
Use this command to display port web authentication information for one or more ports.
show pwa [port-string]
Syntax Description
Command Defaults
If port-string is not specified, PWA information will be displayed for all ports.
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display PWA information for ge.2.1:
Table 14-3 provides an explanation of the command output.
port-string (Optional) Displays PWA information for specific
port(s).
Matrix(rw)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1 foreauthorized disconnected 60 16
To Next Page
Loading...
